59--SEAL,ELECTRONICS BA

WWS 771-229-0569 [email protected] A TBD TBD TBD TBD N/A 365 DAYS AFTER THE LAST DELIVERY UNDER THIS CONTRACT The hour and date specified for receipt of offers has been extended to 4:30PM EST on 09 Sept 2026. The hour and date specified for receipt of offers has been extended to 4:30PM EST on 21 Sept 2026. 1.The resulting award will not contain Government source Inspection (GSI) 2. FAR Clause 52.232-25(a)(5), entitled Prompt Payment, Constructive Acceptance is changed from 7 days to 45 days after delivery of the supplies in accordance with the terms and conditions of the contract. 3. Note to DCMA ACO: Clause NAVSUPWSSGA02 is amended to include Post Award PCO retaining the following functions: FAR 42.302(3), (32), (37), (38), (40),(41),(43), (45 through 51), (60) and (62). 4.The following proposed delivery schedule applies: Final delivery of material (210 days) 5. This requirement falls under the Emergency Acquisition Flexibilities (EAF) in accordance with 41 U.S.C. 1903. 1. SCOPE 1.1 The material covered in this contract/purchase order will be used in a crucial shipboard system. The use of incorrect or defective material would create a high probability of failure resulting in serious personnel injury, loss of life, loss of vital shipboard systems, or loss of the ship itself. Therefore, the material has been designated as SPECIAL EMPHASIS material (Level I, Scope of Certification, or Quality Assured) and special control procedures are invoked to ensure receipt of correct material. 1.1.1 DSSP Scope of Certification Material - Material Control Division ;C; applies to this material. 1.1.2 ;This Electronics Bay Seal has been determined to only be used in a Seal Delivery Vehicle (SDV) application.; 1.1.3 This ;ELECTRONICS BAY SEAL; contains non-metallic materials which must satisfy the toxicity and flammability requirements of NAVSEA ;S9086-AD-SOC-030; . Use of any material other than that specified requires special engineering approval and may require testing. 2. APPLICABLE DOCUMENTS 2.1 Order of Precedence - In the event of a conflict between the text of this contract/purchase order and the references and/or drawings cited herein, the text of this contract/purchase order must take precedence. Nothing in this contract/purchase order, however, must supersede applicable laws and regulations unless a specific exemption has been obtained. 2.2 Applicable Documents - The document(s) listed below form a part of this contract/purchase order including modifications or exclusions. 2.2.1 Specification Revisions - The specification revisions listed under "Documents References" below are the preferred revision. Older and/or newer r evisions are acceptable when listed within Contract Support Library Reference Number CSD155 in ECDS (Electric Contractor Data Submission) at: ht tps://register.nslc.navy.mil/. This is to allow Contractors to use certain acceptable older specification revisions to purge their existing stock of material certified to those older revisions or to use newer specification revisions when material is certified to newly released revisions,without requiring the submittal of waiver/deviation requests for each specification revision on every contract. Revisions of specifications reflecting editorial and/or re-approval (e.g. E2009, R2014, etc.) are considered inconsequential, but are acceptable when their revisions are listedwithin CSD155 or elsewhere within this contract. 2.2.2 "Document References" listed below must be obtained by the Contractor. Ordering information is included as an attachment to this contract/purchase order. 2.2.3 Documents, drawings, and publications supplied are listed under "Drawing Number". These items should be retained until an award is made. DRAWING DATA=8598478-03 B DW D DOCUMENT REF DATA=MIL-STD-130 N A DOCUMENT REF DATA=S9086-AD-SOC-030 B D 1 1 3. REQUIREMENTS 3.1 ;SEAL,ELECTRONICS BAY must be manufactured in accordance with NAVSEA drawing 8598478-03, Part Number 8598478-03-001 excep…