Dry-Dock (DD)USCGC PAMLICO DD FY21

SOURCES SOUGHT NOTICE: USCGC ANVIL DD FY 27. This SOURCES SOUGHT NOTICE is for market research purposes only and does not constitute a Request for Proposal/Quotation; and, it is not considered to be a commitment by the Government to award a contract nor will the Government pay for any information provided; no basis for claim against the Government shall arise as a result from a response to this Sources Sought Notice or Government use of any information provided. Pursuant to FAR Part 10 (Market Research), the purpose of this notice is to: (1) Determine if sources capable of satisfying the agency's requirements exists. (2) Determine if commercial items suitable to meet the agency's needs are available or could be modified to meet the agency's requirements. (3) Determine the commercial practices of company's engaged in providing the needed service or supply. Pursuant to FAR Part 6 and FAR Part 19, competition and set-aside decisions may be based on the results of this market research. This notice in no way obligates the Government to any further action. REQUIREMENT: This notice is issued by the U.S. Coast Guard, CG-DCS-SEA-C, Base New Orleans, LA to identify sources capable of providing the following: The U.S. Coast Guard is looking for sources which would be interested in performing Dry Dock repairs for the United States Coast Guard Cutter (USCGC) Pamlico (WLIC-800). The performance period start date of this upcoming Dry Dock is 9 March 2027 18 May 2027. It is anticipated that the request for proposals will be issued approximately 28 September 2026, and the contract would be awarded around 02 February 2028. The (USCGC) ANVIL (WLIC-800) is a USCG 160-foot ANVIL Class Inland Construction Tender which is currently home ported in New Orleans, LA. The tentative work list will include, but is not limited to the following: Fire Prevention Requirements; Hull Plating, U/W Body, Inspect; Appendages, U/W, Leak Test Appendages, U/W, Internal, Preserve ;Tanks, MP Fuel Stowage and Overflow, Clean and Inspect Voids, Non-Accessible, Leak Test ;Voids, Non-Accessible, Internal Surfaces, Preserve Tanks, MP Fuel Service, Clean and Inspect ;Propulsion Shaft Seals (Inflatable), Overhaul and Inflatable Renewal ;Propulsion Shafting; Remove, Inspect, and Reinstall ;Propulsion Shafting, Straighten ;Mechanical Shaft Seal Assemblies, Renew ; Propulsion Shafting, Optical or Laser Alignment Check ; Propulsion Shaft Bearings, External, Check Clearances ; Propulsion Shaft Bearings, External, Renew ; Propulsion Stern Tube Bearings, Renew; Stern Tube Interior Surfaces, Preserve, 100 Percent; Propeller s, Remove, Inspect, and Reinstall ; Propeller, Minor Repairs and Reconditioning, Perform ; Keel Coolers, Clean, Inspect and Hydro; Fathometer Transducer, Renew Sea Valves and Waster Pieces, Overhaul Or Renew ; Sea Strainers, Duplex, All Sizes, Overhaul Rudder Assembly, Remove, Inspect And Reinstall; Rudders, Preserve, 100 Percent ; Rudder Stock Bearings Clearances, Check ; Rudder Stock Housing, Lower, Renew ; Rudder Stock Housing, Upper, Renew ; Hull Fittings (Mooring and Towing), Inspect & Test; Spud Wells, Preserve ;Spud Wells, Inspect ;Tanks (Sewage Holding), Preserve, 100 percent ;Accessible Voids, Preserve, 100 Percent Tanks, Ballast, Preserve, 100 Percent.; Tanks, Ballast, Preserve, Partial ; Tanks, Dirty Oil and Waste, Preserve, 100 Percent, Tanks, Dirty Oil and Waste, Preserve, Partial, ; Accessible Void(s), Preserve, Partial, ; Tanks, Potable Water Preserve, 100 Percent ; Tanks, Potable Water, Preserve, Partial, ; Decks Exterior (Buoy or Construction Deck), Preserve 100% Cathodic Protection, Zinc Anodes, Renew, ; Drydock ; Temporary Services, Provide - Tender ;Hull Plating, U/W Body, Ultrasonic Testing ; U/W Body, Preserve, ; Hull Plating Freeboard, Preserve, 100 Percent ; Hull and Structural Plating, General, 10.2 lbs. Steel, Renew .; Hull and Structural Plating, General, 12.75 lbs. Steel Plate, Renew ; Hull and Structural Plating, General, 15.3 lbs. Ste…